Everest 400 - Clamping errors - Align frame


- Disc clamping errors on a newly received unit. 
- Disc is being placed on the center pin

The system may have been roughly handled during shipping and the frame is out of alignment.

Re-align the frame. 
1. Remove the top and right side panel of the system. 
2. LOOSEN the screws that secure the frame (see below).

3. With the screws loosened, the frame should settle into proper position. Tighten the screws.
4. Test the system.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request